Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2004 Subaru Baja Base, AutomaticFACTORY OEM SERVICE PROCEDURE
Select Lever: Disassembly
- EXCEPT SPORT SHIFT MODEL
- Remove four washers and then detach rubber boot.
- Remove bolts and then remove cable bracket and plate.
- Remove select lever grip.
- Detach indicator cover and pattern plate.
- Disconnect solenoid assembly connector.
- While pressing shift lock cancel button, remove shift lock solenoid assembly.
- Remove indicator light.
- Remove indicator bulb.
- Remove indicator light cover.
- Remove cushion.
- Tilt lever forward and pull down to separate it from frame.
- Remove clip, and "P" position switch with harness.
- Remove detent spring
- Remove spring.CAUTION: Wear goggles. Do not allow spring to fly out during removal.
- Remove bolt and then disconnect lever upper and lever lower.
- SPORT SHIFT MODEL
- Remove the packing.
- Remove the grip.
- Remove the indicator light, and then remove the indicator cover.NOTE: Be careful not to break the indicator light during removal.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
