Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2003 Subaru Outback L.L. Bean EditionFACTORY OEM SERVICE PROCEDURE
RH Side
- Release fuel pressure.
< Ref. to RELEASING OF FUEL PRESSURE , OPERATION, Fuel.>
- Open fuel flap lid, and remove fuel filler cap.
- Disconnect battery ground cable.
- Remove air cleaner lower case. < Ref. to REMOVAL , Air Cleaner.>
- Remove power steering pump and tank from brackets.
- Remove V-belt. <Ref. to REMOVAL , V-belt.>
- Remove power steering oil pipe with bracket.
- Remove bolts which install power steering pump bracket.CAUTION: Do not separate hose and pipe from the main pump.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.