2003 Subaru Outback L.L. Bean EditionFACTORY OEM SERVICE PROCEDURE

LH Side

  1. Release fuel pressure. < Ref. to RELEASING OF FUEL PRESSUREΒ , OPERATION, Fuel.>
  2. Open fuel flap lid, and remove fuel filler cap.
  3. Disconnect battery ground cable.
    Fig 1: Disconnecting Battery Ground Cable
    G02877147Courtesy of SUBARU OF AMERICA, INC.
  4. Remove two bolts which install washer tank on body.
    Fig 2: Removing Washer Tank Bolts
    G02877148Courtesy of SUBARU OF AMERICA, INC.
  5. Disconnect connector from front window washer motor.
  6. Disconnect connector from rear gate glass washer motor.
    Fig 3: Disconnecting Connector From Rear Gate Glass Washer Motor
    G02877149Courtesy of SUBARU OF AMERICA, INC.
  7. Disconnect rear window glass washer hose from washer motor, then plug connection with a suitable cap.
  8. Move washer tank upward.
    Fig 4: Moving Washer Tank Upward
    G02877150Courtesy of SUBARU OF AMERICA, INC.
  9. Remove ground cable from fuel pipe protector LH.
    Fig 5: Removing Ground Cable From Fuel Pipe Protector LH
    G02877151Courtesy of SUBARU OF AMERICA, INC.
  10. Remove fuel pipe protector LH.
    Fig 6: Removing Fuel Pipe Protector LH
    G02877152Courtesy of SUBARU OF AMERICA, INC.
  11. Disconnect connector (A) from fuel injector.
  12. Remove bolt (B) which holds injector pipe onto cylinder head.
    Fig 7: Removing Injector Pipe Bolt
    G02877153Courtesy of SUBARU OF AMERICA, INC.
  13. Remove fuel injector while lifting up fuel injector pipe.
Chapter Navigation
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.