Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2003 Subaru Outback F6-3.0LFACTORY OEM SERVICE PROCEDURE
VDC Control Module (VDCCM)
VDC Control Module (VDCCM)
REMOVAL

1. Disconnect battery ground cable.

2. Remove lower cover of instrument panel and disconnect connectors on the back side of the cover.

3. Remove three bolts which secure the fuse box onto body side, then move the fuse box aside.

4. Remove two bolts which install VDCCM onto body side bracket.

5. Disconnect connector from VDCCM by pulling up the securing holder.
6. Remove VDCCM.
INSTALLATION
Install in the reverse order of removal.
CAUTION: After completion of installation procedure, the following two position settings must be made.
^ Steering angle sensor center positioning
^ Yaw rate and lateral G sensor 0 positioning These procedures are necessary for VDCCM to later recognize what position the vehicle is in. For procedures for the above two settings. Programming and Relearning
REMOVAL
1. Disconnect battery ground cable.
2. Remove lower cover of instrument panel and disconnect connectors on the back side of the cover.
3. Remove three bolts which secure the fuse box onto body side, then move the fuse box aside.
4. Remove two bolts which install VDCCM onto body side bracket.
5. Disconnect connector from VDCCM by pulling up the securing holder.
6. Remove VDCCM.
INSTALLATION
Install in the reverse order of removal.
CAUTION: After completion of installation procedure, the following two position settings must be made.
^ Steering angle sensor center positioning
^ Yaw rate and lateral G sensor 0 positioning These procedures are necessary for VDCCM to later recognize what position the vehicle is in. For procedures for the above two settings. Programming and Relearning
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
