2003 Subaru Outback F6-3.0LFACTORY OEM SERVICE PROCEDURE

Rear Oxygen Sensor

REMOVAL

Factory service manual diagram



1. Disconnect battery ground cable.

Factory service manual diagram



2. Disconnect connector from rear oxygen sensor.
3. Lift-up the vehicle.
4. Apply SUBARU CRC or its equivalent to threaded portion of rear oxygen sensor, and leave it for one minute or more.

SUBARU CRC (Part No. 004301003)

Factory service manual diagram



5. Remove rear oxygen sensor.

CAUTION: When removing, do not force rear oxygen sensor in an unnatural way especially when exhaust pipe is cold, otherwise it will damage exhaust pipe.

INSTALLATION

1. Before installing rear oxygen sensor, apply anti-seize compound only to threaded portion of rear oxygen sensor to make the next removal easier.

CAUTION: Never apply anti-seize compound to protector of rear oxygen sensor.

Anti-seize compound: SS-30 by JET LUBE

Factory service manual diagram



2. Install rear oxygen sensor.

Tightening torque: 21 N.m (2.1 kgf-m, 15.2 ft-lb)

Factory service manual diagram



3. Connect connector to rear oxygen sensor.
4. Lower the vehicle.

Factory service manual diagram



5. Connect battery ground cable.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.