Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2003 Subaru Forester XS, AutomaticFACTORY OEM SERVICE PROCEDURE
Throttle Body: Removal
- Disconnect the ground cable from battery.
- Remove the air cleaner case. Refer to REMOVAL , Air Cleaner Case.
- Disconnect the accelerator cable (A).
- Disconnect the cruise control cable (B). (With cruise control model)
- Disconnect the connectors from idle air control solenoid valve, throttle position sensor and pressure sensor.
- Disconnect the air by-pass hose from the throttle body.
- Throttle position sensor
- Pressure sensor
- Idle air control solenoid valve
- Air by-pass hose
- Disconnect the engine coolant hoses (A) from the throttle body.
- Remove the bolts (B) which install throttle body to the intake manifold.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.