Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2003 Subaru Forester XS, AutomaticFACTORY OEM SERVICE PROCEDURE
Fuel Sub Level Sensor: Removal
WARNING:
- Place "NO FIRE" signs near the working area.
- Be careful not to spill fuel on the floor.
- Disconnect the ground cable from battery.
- Lift-up the vehicle.
- Drain the fuel from the fuel tank. Set a container under the vehicle and remove the drain plug from the fuel tank.
- Tighten the fuel drain plug.
Tightening torque:
- 26 N.m (2.65 kgf-m, 19.2 ft-lb)
- Remove the rear seat.
- Remove the service hole cover.
- Disconnect the connector from the fuel sub meter.
- Disconnect the fuel jet pump hose.
- Remove the bolts which install the fuel sub meter unit on the fuel tank.
- Remove the fuel sub meter unit.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.