2003 Subaru Forester X, AutomaticFACTORY OEM SERVICE PROCEDURE

Extension Case: Installation

  1. Attach the selected thrust needle bearing to the end surface of reduction drive gear with vaseline.
    NOTE: Install thrust needle bearing in the correct direction.
  2. Install new gasket.
  3. Install the extension case to the transmission case.
  4. Tighten bolts to secure the case.
    1. Tightening torque:Β  25 N.m (2.5 kgf-m, 18.1 ft-lb)
    Fig 1: Tightening Bolts To Secure Case
    G02093160Courtesy of SUBARU OF AMERICA, INC.
  5. Install the rear vehicle speed sensor.
    1. Tightening torque:Β  7 N.m (0.7 kgf-m, 5.1 ft-lb)
    Fig 2: Installing Rear Vehicle Speed Sensor
    G02093161Courtesy of SUBARU OF AMERICA, INC.
  6. Install the transmission assembly. Refer to INSTALLATIONΒ , Automatic Transmission Assembly.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.