Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2003 Subaru Forester X, AutomaticFACTORY OEM SERVICE PROCEDURE
Windshield Glass: Installation
- Clean the external circumference of windshield glass with alcohol or white gasoline.
- Remove the adhesive layer on the body using cutter knife to obtain smooth face 2 mm (0.08 in) thick.
- Clean the body with alcohol or white gasoline to remove thoroughly chips, dusts, and dirts from body face.
- Apply the dam rubber to back of glass.
- Remove the backing of double-faced adhesive tape, and then align the molding mark (B) to notch (A). Attach the molding around the edge of glass, and then press it evenly to fit.
- Apply primer to the adhesive layer of glass using sponge.
- Apply primer to the adhesive layer of body. Primer once attached to the painted surface of the body and internal trim is hard to wipe off. Mask the circumference of such areas.
Let the primer dry for about ten minutes before installing the glass.
- Cut off the cartridge nozzle tip and set it in sealant gun as shown.
- Apply adhesive to the glass end surface as shown.
- Fit the matching pins using suction rubber cup to install the windshield glass.
- Lightly press the windshield glass for tight fit.
- After completion of all work, allow the vehicle to stand for about 24 hours.NOTE: For minimum drying time and time the vehicle must be left standing before driving after bonding, follow instructions or instruction manual from the adhesive manufacturer.
- After curing of adhesive, pour water on external surface of vehicle to check that there are no water leaks.NOTE: When a vehicle is returned to the user, tell him or her that the vehicle should not be subjected to heavy impact for at least three days.
- Install the cowl panel. Refer to INSTALLATION , Cowl Panel.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
