2003 Subaru Forester X, AutomaticFACTORY OEM SERVICE PROCEDURE

Slip Control

SLIP CONTROL

Type of control Increases transfer clutch pressure to the same level as in the 1 range immediately after a slip is detected. 
Gear position 1st thru 4th and reverse 
Remarks Release: The transfer clutch pressure is lowered when a turn under turning control is detected while running faster than the set vehicle speed with fully closed throttle. 
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.