2003 Subaru Forester F4-2.5L SOHCFACTORY OEM SERVICE PROCEDURE

Piston Pin, Engine

Piston pin
Outer diameter 22.994 - 23.000 mm (0.9053 - 0.9055 in.)
Standard clearance between piston pin and piston; 0.004 - 0.008 mm (0.0002 - 0.0003 in)
Degree of fit: Piston pin must be fitted into position with thumb at 20°C (68°F)
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.