2003 Subaru Forester F4-2.5L SOHCFACTORY OEM SERVICE PROCEDURE

Fuel Sub Level Sensor

REMOVAL

WARNING:
- Place "NO FIRE" signs near the working area.
- Be careful not to spill fuel on the floor.


Factory service manual diagram



1. Disconnect the ground cable from battery
2. Lift-up the vehicle.

Factory service manual diagram



3. Drain the fuel from the fuel tank. Set a container under the vehicle and remove the drain plug from the fuel tank.

Factory service manual diagram



4. Tighten the fuel drain plug.

Tightening torque: 26 N.m (2.65 kgf.m, 19.2 ft.lb)

5. Remove the rear seat

Factory service manual diagram



6. Remove the service hole cover.
7. Disconnect the connector from the fuel sub meter.

Factory service manual diagram



8. Disconnect the fuel jet pump hose.

Factory service manual diagram



9. Remove the bolts which install the fuel sub meter unit on the fuel tank.

Factory service manual diagram



10. Remove the fuel sub meter unit.

INSTALLATION

Factory service manual diagram



Install in the reverse order of removal.

Tightening torque: 4.4 N.m (0.45 kgf.m, 3.3 ft.lb)
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.