2003 Subaru Forester F4-2.5L SOHCFACTORY OEM SERVICE PROCEDURE

Control Assembly: Service and Repair

Control Unit

REMOVAL

1. Disconnect the ground cable from battery.
2. In case of manual A/C, remove the mode cable and air-mix cable from links of heater unit.

Factory service manual diagram



3. Remove the front cover.

Factory service manual diagram



4. Remove the center console panel.
5. Loosen the screws on rear side of center console panel, and then remove the control unit.

INSTALLATION

Install in the reverse order of removal.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.