2003 Subaru Baja AutomaticFACTORY OEM SERVICE PROCEDURE

Select Cable: Removal

  1. Set the vehicle on a lift.
  2. Disconnect the ground cable from battery.
  3. Prior to removal, set the lever to "N" position.
  4. Lift-up the vehicle.
  5. Remove the front and center exhaust pipe.

    2.5 L model 

    1. < Ref. to REMOVAL , Front Exhaust Pipe.>

    3.0 L model 

    1. < Ref. to REMOVAL , Front Exhaust Pipe.>
  6. Remove the heat shield cover. (If equipped)
  7. Remove the snap pin from range select lever.
    Fig 1: Removing Snap Pin From Range Select Lever
    G02876270Courtesy of SUBARU OF AMERICA, INC.
  8. Remove the plate assembly from transmission case.
    Fig 2: Removing Plate Assembly From Transmission Case
    G02876271Courtesy of SUBARU OF AMERICA, INC.
  9. Disconnect the cable from select lever, and then remove the cable bracket.
    Fig 3: Disconnecting Cable From Select Lever
    G02876272Courtesy of SUBARU OF AMERICA, INC.
  10. Remove the select cable from plate assembly.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.