2003 Subaru Baja AutomaticFACTORY OEM SERVICE PROCEDURE

Select Cable: Adjustment

  1. Set the vehicle on a lift.
  2. Set the lever to "N" position.
  3. Lift-up the vehicle.
  4. Remove the rear exhaust pipe and muffler.
  5. Remove the heat shield cover. (If equipped)
  6. Loosen the adjusting nut on each side.
    Fig 1: Loosening Adjusting Nut On Each Side
    G02876275Courtesy of SUBARU OF AMERICA, INC.
  7. Turn the adjusting nut B until it lightly touches the connector.
    Fig 2: Turning Adjusting Nut B Until It Lightly Touches Connector
    G02876276Courtesy of SUBARU OF AMERICA, INC.
  8. While preventing the adjusting nut B from moving with a wrench, tighten the adjusting nut A.
    1. Tightening torque:Β  7.5 N.m (0.76 kgf-m, 5.5 ft-lb)
    Fig 3: Tightening Adjusting Nut A
    G02876277Courtesy of SUBARU OF AMERICA, INC.
  9. After completion of fitting, make sure that the select lever operates smoothly all across the operating range.
  10. Install in the reverse order of removal.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.