2003 Subaru Baja AutomaticFACTORY OEM SERVICE PROCEDURE

Variable Torque Distribution Center Differential

The front-rear torque distribution ratio is basically determined by the gear tooth ratio of center differential's compound planetary gears and varied by changing the degree of engagement of the hydraulically operated multi-plate clutch that connects the center differential output elements according to driving conditions and road surface conditions. The torque distribution ratio is calculated using the following equations which include torque distribution coefficients (determined by number of gear teeth), input torque to the center differential, and torque capacity of the multi-plate clutch as factors.

  1. When the front wheel speed is higher than the rear wheel speed:

    TR = 0.545 x Ti + Tc

    TF = 0.455 x Ti + Tc

    where

    TR : Rear wheel output torque

    Ti : Input torque to center differential

    Tc : Torque capacity of multi-plate clutch

    TF : Front wheel output torque

    0.545: Coefficient of rear wheel torque determined by number of gear teeth

    0.455: Coefficient of front wheel torque determined by number of gear teeth

    Fig 1: Power Flow Chart - When Front Wheel Speed Is Higher Than Rear Wheel Speed
    G02077173Courtesy of SUBARU OF AMERICA, INC.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.