2003 Subaru Baja AutomaticFACTORY OEM SERVICE PROCEDURE

Read Diagnostic Trouble Code

  1. Prepare Subaru Select Monitor kit. < Ref. to PREPARATION TOOLΒ  , General Description.>
    Fig 1: Identifying Subaru Select Monitor Kit
    G02875564Courtesy of SUBARU OF AMERICA, INC.
  2. Connect diagnosis cable to Subaru Select Monitor.
  3. Insert cartridge into Subaru Select Monitor.
    Fig 2: Inserting Cartridge Into Subaru Select Monitor
    G02875565Courtesy of SUBARU OF AMERICA, INC.
  4. Connect Subaru Select Monitor to data link connector.
    1. Data link connector located in the lower portion of the instrument panel (on the driver's side).
      Fig 3: Connecting Subaru Select Monitor To Data Link Connector
      G02875566Courtesy of SUBARU OF AMERICA, INC.
    2. Connect diagnosis cable to data link connector.
      NOTE: Do not connect scan tools except for Subaru Select Monitor and OBD-II general scan tool.
  5. Turn ignition switch to ON (engine OFF) and Subaru Select Monitor switch to ON.
    Fig 4: Turning Ignition Switch ON
    G02875567Courtesy of SUBARU OF AMERICA, INC.
  6. On the "Main Menu" display screen, select the {Each System Check} and press the [YES] key.
  7. On the "System Selection Menu" display screen, select the {Transmission Control System} and press the [YES] key.
  8. Press the [YES] key after displayed the information of transmission type.
  9. On the transmission Diagnosis" display screen, select the {Diagnostic Code(s) Display} and press the [YES] key.
  10. On the "Diagnostic Code(s) Display" display screen, select the {Latest Diagnostic Code(s)} or {Memorized Diagnostic Code(s)} and press the [YES] key.
    NOTE:
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.