Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

2003 Subaru Baja AutomaticFACTORY OEM SERVICE PROCEDURE

Spark Plugs

SPARK PLUG TYPE

Application	Champion	NGK
2.0L	N/A	PFR6G
2.5L	RC10YC4	BKR5E-11 Or BKR6E-11
3.0L	N/A	PLFR6A-11

SPARK PLUG SPECIFICATIONS

Application

Gap - In. (mm)

⁽¹⁾ Torque - Ft. Lbs. (N.m)

2.0L

0.028-0.031 (0.7-0.8)

15 (21)

2.5L & 3.0L

0.039-0.043 (1.0-1.1)

15 (21)

⁽¹⁾	Torque should only be applied to new spark plugs without oil on the threads. In case threads are lubricated, torque should be reduced by approximately 1/3 of specified torque in order to avoid over stressing.

Chapter Navigation

Return to Chapter: Ignition System

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready Tools Compare Repair Quote Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.