Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2002 Subaru Outback L.L.Bean Edition AWD F6-3.0LFACTORY OEM SERVICE PROCEDURE
Spark Plug: Specifications
SPECIFICATIONS
Spark Plug Thread Size 14, P = 1.25
Spark Plug Spark Gap 1.0 - 1.1 (0.039 - 0.043)
SPARK PLUG
RH SIDE
Tightening Torque (Spark plug): 21 Nm (2.1 kgf-m, 15 ft-lb)
CAUTION: The above torque should be only applied to new spark plugs without oil on their threads. In case their threads are lubricated, the torque should be reduced by approximately 1/3 of the specified torque in order to avoid over-stressing.
Tightening Torque (Ignition coil): 16 Nm (1.6 kgf-m, 12 ft-lb)
LH SIDE
Tightening Torque (Spark plug): 21 Nm (2.1 kgf-m, 15 ft-lb)
CAUTION: The above torque should be only applied to new spark plugs without oil on their threads. In case their threads are lubricated, the torque should be reduced by approximately 1/3 of the specified torque in order to avoid over-stressing.
Tightening Torque (Ignition coil): 16 Nm (1.6 kgf-m, 12 ft-lb)
Spark Plug Thread Size 14, P = 1.25
Spark Plug Spark Gap 1.0 - 1.1 (0.039 - 0.043)
SPARK PLUG
RH SIDE
Tightening Torque (Spark plug): 21 Nm (2.1 kgf-m, 15 ft-lb)
CAUTION: The above torque should be only applied to new spark plugs without oil on their threads. In case their threads are lubricated, the torque should be reduced by approximately 1/3 of the specified torque in order to avoid over-stressing.
Tightening Torque (Ignition coil): 16 Nm (1.6 kgf-m, 12 ft-lb)
LH SIDE
Tightening Torque (Spark plug): 21 Nm (2.1 kgf-m, 15 ft-lb)
CAUTION: The above torque should be only applied to new spark plugs without oil on their threads. In case their threads are lubricated, the torque should be reduced by approximately 1/3 of the specified torque in order to avoid over-stressing.
Tightening Torque (Ignition coil): 16 Nm (1.6 kgf-m, 12 ft-lb)
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.