2002 Subaru Outback L.L.Bean Edition AWD F6-3.0LFACTORY OEM SERVICE PROCEDURE

Ignition Shut Down Relay (For Antitheft): Testing and Inspection

Factory service manual diagram



INSPECTION

Measure the interrupt relay resistance between terminals (indicated in the table) while connecting terminal No.4 to battery positive terminal and terminal No.1 to battery ground terminal.
If NG, replace the interrupt relay.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.