2002 Subaru Outback L.L.Bean Edition AWD F6-3.0LFACTORY OEM SERVICE PROCEDURE

Cruise Control Command Switch

Cruise Control Command Switch

REMOVAL

WARNING: Before servicing, be sure to read the notes in the Airbag section for proper handling of the driver's airbag module.

1. Set front wheels in straight ahead position.
2. Turn ignition switch OFF.
3. Disconnect ground cable from battery and wait for at least 20 seconds before starting work.

Factory service manual diagram



4. Using TORX(R) BIT T30 (Tamper resistant type), loosen two TORX(R) bolts which secure driver's airbag module.
5. Disconnect airbag module connector on back of airbag module.

Factory service manual diagram



6. Remove horn switch from steering wheel as shown.

Factory service manual diagram



7. Disconnect horn and cruise control command switch connector, then remove cruise control command switch.

INSTALLATION

Install is in the reverse order of removal.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.