2002 Subaru Outback L.L. Bean EditionFACTORY OEM SERVICE PROCEDURE

Select Lever: Disassembly

  1. Remove four washers and then detach rubber boot.
  2. Remove bolts and then remove cable bracket and plate.
  3. Twist the select lever grip and then remove select lever grip.
  4. Detach indicator cover and pattern plate.
    Fig 1: Removing Indicator Cover & Pattern Plate
    G02960739Courtesy of SUBARU OF AMERICA, INC.
  5. Disconnect solenoid assembly connector.
  6. While pressing shift lock cancel button, remove shift lock solenoid assembly.
    Fig 2: Removing Shift Lock Solenoid Assembly
    G02960740Courtesy of SUBARU OF AMERICA, INC.
  7. Remove illumination light.
    Fig 3: Removing Illumination Light
    G02960741Courtesy of SUBARU OF AMERICA, INC.
  8. Remove illumination bulb.
  9. Remove illumination light cover.
    Fig 4: Removing Illumination Light Cover
    G02960742Courtesy of SUBARU OF AMERICA, INC.
  10. Remove stopper.
    Fig 5: Removing Stopper
    G02960743Courtesy of SUBARU OF AMERICA, INC.
  11. Tilt lever forward and pull down to separate it from frame.
    Fig 6: Removing Lever From Frame
    G02960744Courtesy of SUBARU OF AMERICA, INC.
  12. Remove clip, and "P" position switch with harness.
    Fig 7: Removing Clip & "P" Position Switch With Harness
    G02960745Courtesy of SUBARU OF AMERICA, INC.
  13. Remove detent spring
    Fig 8: Removing Detent Spring
    G02960746Courtesy of SUBARU OF AMERICA, INC.
  14. Remove spring.
    CAUTION: Wear goggles. Do not allow spring to fly out during removal.Β 
  15. Remove bolt and then disconnect lever upper and lever lower.
Fig 9: Disconnecting Upper & Lower Lever
G02960747Courtesy of SUBARU OF AMERICA, INC.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.