2002 Subaru Outback L.L. Bean EditionFACTORY OEM SERVICE PROCEDURE

Select Cable: Installation

  1. Install select cable to plate assembly.
    1. Tightening torque:  32 N.m (3.3 kgf-m, 24 ft-lb)
  2. Install select cable to range select lever.
  3. Install plate assembly to transmission.

    Tightening torque: 

    1. T:  24.5 N.m (2.5 kgf-m, 18.1 ft-lb)
    Fig 1: Installing Plate Assembly To Transmission
    G02960752Courtesy of SUBARU OF AMERICA, INC.
  4. Install snap pin to range select lever.
    Fig 2: Installing Snap Pin To Range Select Lever
    G02960753Courtesy of SUBARU OF AMERICA, INC.
  5. Move the select lever to the "N" position, then adjust the select cable position. Refer to ADJUSTMENT  , Select Cable.
  6. Install heat shield cover.
    Fig 3: Installing Heat Shield Cover
    G02960754Courtesy of SUBARU OF AMERICA, INC.
  7. Install rear exhaust pipe to muffler.

    2.5 L model 

    Refer to INSTALLATION , Rear Exhaust Pipe and INSTALLATION , Muffler.

    3.0 L model 

    Refer to INSTALLATION , Rear Exhaust Pipe and INSTALLATION , Muffler.

  8. Install under cover.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.