2002 Subaru Outback L.L. Bean EditionFACTORY OEM SERVICE PROCEDURE

Select Cable: Inspection

Check the removed cable and replace if damaged, rusty, or malfunctioning.

  1. Check for smooth operation of the cable.
  2. Check inner cable for damage and rust.
  3. Check outer cable for damage, bends, and cracks.
  4. Check boot for damage, cracks, and deterioration.
  5. Move select lever from "P" position to "1" position. You should be able to feel the detents in each position. If the detents cannot be felt or the position pointer is improperly aligned, adjust the cable.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.