2002 Subaru Outback L.L. Bean EditionFACTORY OEM SERVICE PROCEDURE

Rear Oxygen Sensor: Removal

  1. Disconnect battery ground cable.
    Fig 1: Disconnecting Battery Ground Cable
    G03584269Courtesy of SUBARU OF AMERICA, INC.
  2. Disconnect connector from rear oxygen sensor.
    Fig 2: Disconnecting Connector From Rear Oxygen Sensor
    G03584270Courtesy of SUBARU OF AMERICA, INC.
  3. Lift-up the vehicle.
  4. Apply SUBARU CRC or its equivalent to threaded portion of rear oxygen sensor, and leave it for one minute or more.

    SUBARU CRC (Part No. 004301003)Β 

  5. Remove rear oxygen sensor.
    CAUTION: When removing, do not force rear oxygen sensor in an unnatural way especially when exhaust pipe is cold, otherwise it will damage exhaust pipe.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.