Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2002 Subaru Outback L.L. Bean EditionFACTORY OEM SERVICE PROCEDURE
LH Side
- Release fuel pressure. < Ref. to , RELEASING OF FUEL PRESSURE , OPERATION, FUEL. >
- Open fuel flap lid, and remove fuel filler cap.
- Disconnect battery ground cable.
- Remove two bolts which install washer tank on body.
- Disconnect connector from front window washer motor.
- Disconnect connector from rear gate glass washer motor.
- Disconnect rear window glass washer hose from washer motor, then plug connection with a suitable cap.
- Move washer tank upward.
- Remove ground cable from fuel pipe protector LH.
- Remove fuel pipe protector LH.
- Disconnect connector (A) from fuel injector.
- Remove bolt (B) which holds injector pipe onto cylinder head.
- Remove fuel injector while lifting up fuel injector pipe.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.