Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2002 Subaru Outback L.L. Bean EditionFACTORY OEM SERVICE PROCEDURE
To Program Transmitters
- Open driver's door.
- Close driver's door.
- Press and release any transmitter button that you wish to program into the system. Horn will chirp twice to indicate that the transmitter has been programmed.
NOTE:
You must finish the next step (opening the driver's door) within 45 seconds of starting the PROGRAMMING procedure.
NOTE:
Any additional transmitters may also be programmed at this time. Repeat the above steps for each additional transmitter.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.