Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2002 Subaru Outback Base, 4D SedanFACTORY OEM SERVICE PROCEDURE
Select Cable: Installation
- Install select cable to plate assembly.
- Tightening torque: 32 N.m (3.3 kgf-m, 24 ft-lb)
- Install select cable to range select lever.
- Install plate assembly to transmission.
Tightening torque:
- T: 24.5 N.m (2.5 kgf-m, 18.1 ft-lb)
- Install snap pin to range select lever.
- Move the select lever to the "N" position, then adjust the select cable position. Refer to ADJUSTMENT , Select Cable.
- Install heat shield cover.
- Install rear exhaust pipe to muffler.
2.5 L model
Refer to INSTALLATION , Rear Exhaust Pipe and INSTALLATION , Muffler.
3.0 L model
Refer to INSTALLATION , Rear Exhaust Pipe and INSTALLATION , Muffler.
- Install under cover.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
