2002 Subaru Outback Base, 4D SedanFACTORY OEM SERVICE PROCEDURE

Transmission Control Module (TCM): Removal

  1. Disconnect battery ground cable.
    Fig 1: Disconnecting Battery Ground Cable
    G02960493Courtesy of SUBARU OF AMERICA, INC.
  2. Remove lower cover and then disconnect connector.
    Fig 2: Removing Lower Cover & Disconnecting Connector
    G02960494Courtesy of SUBARU OF AMERICA, INC.
  3. Disconnect connectors from transmission control module.
    Fig 3: Disconnecting Connectors From Transmission Control Module (MPT Model)
    G02960495Courtesy of SUBARU OF AMERICA, INC.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.