Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2002 Subaru Forester L, AutomaticFACTORY OEM SERVICE PROCEDURE
Sub-Switch (Front)
Measure switch resistance.
Front passenger's door switch:
POWER WINDOW CONTROL SUB-SWITCH (FRONT) RESISTANCE SPECIFICATIONS - FRONT PASSENGER'S DOOR SWITCH
| Switch position | Terminal No. | Standard |
|---|---|---|
| UP | 8 and 3 and 5, 4 and 7 | Less than 1 ohm |
| OFF | 4 and 7, 6 and 5 | Less than 1 ohm |
| DOWN | 8 and 3 and 7, 6 and 5 | Less than 1 ohm |
If NG, replace the sub-switch.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.