Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUBARU2002FORESTER BASEREPAIR AND DIAGNOSISSTEERINGPOWER STEERINGPOWER ASSISTED SYSTEMOIL PUMPINSTALLATION
2002 Subaru Forester Base
Oil Pump: Installation
2002 Subaru Forester BaseSECTION Installation
- Install bracket on engine.
- Tightening torque: 22 N.m (2.2 kgf-m, 15.9 ft-lb)
- Install oil pump on oil tank as follows outside the vehicle.NOTE: Prior to installation, make sure that all oil is removed from oil pump, oil tank and pipe.
- Place oil pump in a vise and install stay to oil pump.CAUTION: Do not place oil pump directly in vise; use soft pads and hold oil pump lightly to protect it.
- Tightening torque: 15.7 N.m (1.60 kgf-m, 11.6 ft-lb)
- Install lower shell to oil pump.
- Tightening torque: 18 N.m (1.8 kgf-m, 13.0 ft-lb)
CAUTION: Be sure to use a new seal washer.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.