2002 Subaru Forester BaseFACTORY OEM SERVICE PROCEDURE

Section 2 (Clutch System): General Description: Specifications

WARNING: This page is about a different variant/trim than selected.
Clutch System General Specifications Chart

Model Non-turbo
Clutch cover Type Push type
Diaphragm set load kg (lb) 580 (1,279)
Clutch disc Facing material Woven (Non asbestos)
O.D. x I.D. x thickness mm (in) 225 x 150 x 3.5 (8.86 x 5.91 x 0.138)
Spline O.D. mm (in) 25.2 (0.992), (No. of teeth: 24)
Depth of rivet head Standard mm (in) 1.65 - 2.25 (0.0650 - 0.0886)
Limit of sinking mm (in) 0.3 (0.012)
Limit for deflection mm (in) 1.0 (0.039) at R = 107 (4.21)
Clutch release lever ratio 1.6
Clutch release bearing Grease-packed self-aligning
Clutch pedal Full stroke mm (in) 130 - 135 (5.12 - 5.31)
Clutch release lever Stroke mm (in) 12 - 13.6 (0.472 - 0.535)
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.