Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2002 Subaru Forester BaseFACTORY OEM SERVICE PROCEDURE
Section 2 (Clutch System): Flywheel: Installation
WARNING: This page is about a different variant/trim than selected.
- Install flywheel and ST.
ST 498497100:Β CRANKSHAFT STOPPER
- Tighten the flywheel attaching bolts to the specified torque.NOTE: Tighten flywheel installing bolts gradually. Each bolt should be tightened to the specified torque in a crisscross fashion.
Tightening torque:Β 72 N.m (7.3 kgf-m, 52.8 ft-lb)
- Install clutch disc and cover. Refer to INSTALLATION under CLUTCH DISC AND COVERΒ .
- Install transmission assembly. Refer to INSTALLATION under MANUAL TRANSMISSION ASSEMBLY .
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
