Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2002 Subaru Forester BaseFACTORY OEM SERVICE PROCEDURE
Select Cable: Installation
WARNING: This page is about a different car, the 2003 Subaru Impreza. However, it is still accessible from the selected car via links, so may be relevant.
- Install the select cable to plate assembly.
Tightening torque: 18 N.m (1.8 kgf-m, 13.0 ft-lb)
- Install the select cable to range select lever.
- Install the plate assembly to transmission.
Tightening torque: T: 24.5 N.m (2.5 kgf-m, 18.1 ft-lb)
- Install the washer and snap pin to range select lever.
- Insert the thread portion of the other inner cable and into connector hole of the select lever, and fix the other outer cable end to bracket.
Tightening torque: 18 N.m (1.8 kgf-m, 13.0 ft-lb)
- Move the select lever to the "N" position, then adjust the select cable position. See ADJUSTMENT .
- Install the heat shield cover. (If equipped)
- Install the front and center exhaust pipe. (Non-turbo model) See INSTALLATION (FRONT EXHAUST PIPE) .
- Install the center exhaust pipe. (Turbo model) See INSTALLATION (CENTER EXHAUST PIPE) .
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.