2002 Subaru Forester BaseFACTORY OEM SERVICE PROCEDURE

Stop Light Switch

WARNING: This page is about a different car, the 2004 Subaru Forester. However, it is still accessible from the selected car via links, so may be relevant.

Measure the stop light switch resistance.

Fig 1: Measuring Stop Light Switch Resistance
G03540526Courtesy of SUBARU OF AMERICA, INC.
TERMINAL CHART

Switch position Terminal No. Standard
When brake pedal is depressed 1 and 2: Without cruise control
2 and 3: With cruise control
Less than 1 ohm
When brake pedal is released More than 1 Mohm
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.