Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2002 Subaru Forester BaseFACTORY OEM SERVICE PROCEDURE
Section 186 (Lighting System): General Description: Specifications
WARNING: This page is about a different car, the 2004 Subaru Forester. However, it is still accessible from the selected car via links, so may be relevant.
LIGHTING SYSTEM SPECIFICATIONS CHART
| Headlight | 12 V - 55 W/60 W | |
| Front turn signal light | 12 V - 21 W | |
| Clearance light | 12 V - 5 W | |
| Side marker light | 12 V - 5 W | |
| Front fog light | 12 V - 55 W | |
| Rear combination light | Tail/Stop light | 12 V - 5/21 W |
| Turn signal light | 12 V - 21 W | |
| Back-up light | 12 V - 16 W | |
| License plate light | 12 V - 5 W | |
| High-mounted stop light | Standard type | 12 V - 13 W |
| Rear spoiler built-in type | 12 V - 1.2 W | |
| Room light | 12 V - 8 W | |
| Spot light | 12 V - 8 W | |
| Luggage room light | 12 V - 5 W | |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.