2002 Subaru Forester BaseFACTORY OEM SERVICE PROCEDURE

Select Lever: Removal

WARNING: This page is about a different car, the 2004 Subaru Forester. However, it is still accessible from the selected car via links, so may be relevant.
  1. Set the vehicle on a lift.
  2. Disconnect the ground cable from battery.
  3. Move the select lever to "N" range.
  4. Lift-up the vehicle.
  5. Remove the rear exhaust pipe and muffler.

    Non-turbo model 

    < Ref. to REMOVAL , Rear Exhaust Pipe . > < Ref. to REMOVAL , Muffler . >

    Turbo model 

    < Ref. to REMOVAL , Rear Exhaust Pipe . > < Ref. to REMOVAL , Muffler . >

  6. Remove the heat shield cover. (If equipped)
  7. Disconnect the cable from select lever, and then remove the cable bracket.
    Fig 1: Disconnecting Cable From Select Lever
    G00937546Courtesy of SUBARU OF AMERICA, INC.
  8. Lower the vehicle.
  9. Remove the console box. < Ref. to REMOVAL , Console Box . >
  10. Disconnect the connectors, then remove the four bolts to take out the select lever assembly from body.
    Fig 2: Identifying Bolts & Body
    G00937547Courtesy of SUBARU OF AMERICA, INC.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.