Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

2002 Subaru Forester BaseFACTORY OEM SERVICE PROCEDURE

Select Cable: Installation

WARNING: This page is about a different car, the 2004 Subaru Forester. However, it is still accessible from the selected car via links, so may be relevant.

Install the select cable to plate assembly.
1. Tightening torque: 18 N.m (1.8 kgf-m, 13.0 ft-lb)
Install the select cable to range select lever.
Install the plate assembly to transmission.
1. Tightening torque: T: 24.5 N.m (2.5 kgf-m, 18.1 ft-lb)
Fig 1: Identifying Adjusting Nuts
Courtesy of SUBARU OF AMERICA, INC.
Install the washer and snap pin to range select lever.

Fig 2: Identifying Washer
Courtesy of SUBARU OF AMERICA, INC.
Move the select lever to "N" range, then adjust the select cable position.< Ref. to ADJUSTMENT . >
Install the heat shield cover. (If equipped)
Install the front and center exhaust pipe.
Non-turbo model

< Ref. to REMOVAL , Front Exhaust Pipe . >

Turbo model

< Ref. to INSTALLATION , Front Exhaust Pipe . >

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready Tools Compare Repair Quote Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.