Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUBARU2002FORESTER BASEREPAIR AND DIAGNOSISENGINE MECHANICALFUEL SYSTEMFUEL INJECTION (FUEL SYSTEMS)ROLL OVER VALVEINSTALLATION
2002 Subaru Forester Base
Roll Over Valve: Installation
2002 Subaru Forester BaseSECTION Installation
Install in the reverse order of removal.
CAUTION:
- Do not install top side of valve down.
- Before installing bracket on body, securely fit concave part of bracket to hole in body.
- Connect hoses to roll over valve as shown in Figure.
- While blowing through open end of hose, tilt valve at least 90° left and right from normal position.
- Ensure that there is no air flow when hose is tilted greater than 90°.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.