2002 Subaru Forester BaseFACTORY OEM SERVICE PROCEDURE

Front Regulator and Motor Assembly: Removal

  1. Remove door trim. Refer to REMOVAL , Front Door Trim.
  2. Remove sealing cover. Refer to REMOVAL , Front Sealing Cover.
  3. Remove door glass. Refer to REMOVALΒ  , Front Door Glass.
  4. Disconnect electrical connector.
  5. Loosen four bolts and two nuts to pull out regulator assembly.
    Fig 1: Removing Bolts/Nuts To Pull Out Regulator Assembly
    G02863870Courtesy of SUBARU OF AMERICA, INC.
  6. Loosen screws to remove motor assembly.
    Fig 2: Removing Motor Assembly Screws
    G02863871Courtesy of SUBARU OF AMERICA, INC.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.