Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUBARU2002FORESTER BASEREPAIR AND DIAGNOSIS (SINGLE PAGE)TRANSMISSIONAUTOMATIC TRANSA/T CONTROL SYSTEMSSELECT LEVERASSEMBLY
2002 Subaru Forester Base
Select Lever: Assembly
2002 Subaru Forester BaseSECTION Assembly
- Clean all parts before assembly.
- Apply grease [NIGTIGHT LYW No. 2 or equivalent] to each part. Refer to COMPONENT under GENERAL DESCRIPTION .
- Assemble in the reverse order of disassembly.NOTE:
- When installing the lock plate, be careful to position it in the correct direction.
- Be careful to install the spring and button into the select lever grip in the correct direction.
- After completing the fitting, transfer the select lever to position "P"-"1", then check whether the indicator and select lever agree, whether the pointer and select lever agree, and what the operating force is.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.