Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSSUBARU2002FORESTER BASEREPAIR AND DIAGNOSIS (SINGLE PAGE)ENGINE PERFORMANCEENGINE CONTROL SYSTEMSFUEL INJECTION (FUEL SYSTEMS)ROLL OVER VALVEREMOVAL

2002 Subaru Forester Base

Roll Over Valve: Removal

2002 Subaru Forester BaseSECTION Removal

Lift-up the vehicle.
Remove roll over valve from bracket.

Fig 1: Removing Roll Over Valve
Courtesy of SUBARU OF AMERICA, INC.
Disconnect hoses from roll over valve, and remove it from bracket.

Fig 2: Disconnecting Hoses From Roll Over Valve
Courtesy of SUBARU OF AMERICA, INC.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.