Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUBARU2002FORESTER BASEREPAIR AND DIAGNOSIS (SINGLE PAGE)ENGINE MECHANICALFUEL SYSTEMFUEL INJECTION (FUEL SYSTEMS)ENGINE CONTROL MODULEREMOVAL
2002 Subaru Forester Base
Engine Control Module: Removal
2002 Subaru Forester BaseSECTION Removal
- Disconnect battery ground cable.
- Remove lower inner trim of passenger side. LOWER INNER TRIM
- Detach floor mat of front passenger seat.
- Remove protect cover.
- Remove nuts (A) which hold ECM to bracket.
- Remove clip (B) from bracket.
- Disconnect ECM connectors and take out ECM.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.