2002 Subaru Forester BaseFACTORY OEM SERVICE PROCEDURE

Cruise Control Module: Removal

  1. Disconnect ground cable from battery.
  2. Remove front pillar lower trim.
    Fig 1: Removing Front Pillar Lower Trim
    G02864130Courtesy of SUBARU OF AMERICA, INC.
  3. Disconnect connector from cruise control module.
  4. Remove bolt, then remove cruise control module.
    Fig 2: Removing Cruise Control Module
    G02864131Courtesy of SUBARU OF AMERICA, INC.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.