2001 Subaru Outback L.L. Bean EditionFACTORY OEM SERVICE PROCEDURE

Select Cable: Installation

  1. Install select cable to plate assembly.

    Tightening torque: 

    1. 32 N.m (3.3 kgf-m, 24 ft-lb) 
  2. Install select cable to range select lever.
  3. Install plate assembly to transmission.

    Tightening torque: 

    1. T: 24.5 N.m (2.5 kgf-m, 18.1 ft-lb) 
      Fig 1: Installing Plate Assembly
      G02036908
  4. Install snap pin to range select lever.
    Fig 2: Installing Snap Pin
    G02036909
  5. Move the select lever to the "N" position, then adjust the select cable position. See ADJUSTMENT .
  6. Install heat shield cover.
    Fig 3: Installing Heat Shield Cover
    G02036910
  7. Install rear exhaust pipe to muffler.
  8. Install under cover.
Chapter Navigation
Return to Chapter: Select Cable
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.