2001 Subaru Outback Base, StandardFACTORY OEM SERVICE PROCEDURE

Main Shaft Assembly: Installation

  1. Install the needle bearing and oil seal onto the front of transmission main shaft assembly.
    CAUTION:
    • Wrap clutch splined section with vinyl tape to prevent damage to oil seal.
    • Apply grease (Unilube #2 or equivalent) to the sealing lip of oil seal.
    • Use a new one.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.