2001 Subaru Outback Base, StandardFACTORY OEM SERVICE PROCEDURE

Transmission Case Assembly

Drive pinion shim adjustment Hypoid gear backlash

  1. 0.13 - 0.18 mm (0.0051 - 0.0071 in)
    Fig 1: Drive Pinion Shim Adjustment Chart
    G02037101

Selection of main shaft rear plate

Fig 2: Selecting Main Shaft Rear Plate Chart
G02037102
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.