2001 Subaru Outback Base, StandardFACTORY OEM SERVICE PROCEDURE

Master Cylinder: Installation

  1. Install master cylinder to body, and install clutch pipe to master cylinder.
    CAUTION: Check that pipe is routed properly.

    Tightening torque:Β 

    1. T1:Β  15 N.m (1.5 kgf-m, 10.8 ft-lb)
    2. T2:Β  18 N.m (1.8 kgf-m, 13.0 ft-lb)
      Fig 1: Installing Master Cylinder & Clutch Pipe
      G02037378
  2. Connect push rod of master cylinder to clutch pedal, and install clevis pin and snap pin.
    NOTE: Apply grease to clevis pin.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.