2001 Subaru Outback Base, StandardFACTORY OEM SERVICE PROCEDURE

Master Cylinder: Disassembly

  1. Remove straight pin and reservoir tank.
    Fig 1: Removing Straight Pin & Reservoir Tank
    G02037380
  2. Remove oil seal.
    Fig 2: Removing Oil Seal
    G02037381
  3. Move the cylinder boot backward.
    Fig 3: Identifying Cylinder Boot
    G02037382
  4. Remove snap ring.
    CAUTION: Be careful when removing the snap ring to prevent the rod, washer, piston and return spring from flying out.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.