Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2001 Subaru Outback Base, StandardFACTORY OEM SERVICE PROCEDURE
Clutch System: Flywheel: Removal
- Remove transmission assembly. See MANUAL TRANSMISSION ASSEMBLY .
- Install ST on flywheel.
ST 498497100 CRANKSHAFT STOPPER
- Remove clutch cover and clutch disc. See Clutch Disc and Cover
.CAUTION:
- Take care not to allow oil on the clutch disc facing.
- Do not disassemble either clutch cover or clutch disc.
- Using ST, remove flywheel.
ST 498497100 CRANKSHAFT STOPPER
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.